石景山区PVC排水管-Gafloon卡弗龙-PVC排水管制造

• 供货总量 : 不限
• 价格说明 : 议定
• 包装说明 : 不限
• 物流说明 : 货运及物流
• 交货说明 : 按订单

铺设好的冷热水管一定要用卡扣固定好，PVC排水管生产，避免后期装修过程中水管移位，导致接头脱落、松动，产生漏水隐患。尽量做到每隔60cm就要安装一个卡子，切记卡子安装一定要牢固。成品保护很重要，铺设的水管，避免有重物压在水管上。

Water pipe le

The laid cold and hot water pipe must be fixed with clamps to avoid the displacement of the water pipe in the later decoration process，石景山区PVC排水管， which leads to the joint falling off and loosening， and the potential water leakage will occur. Try to install a clip every 60cm，PVC排水管制造， and remember that the clip must be firmly installed. The finished product protection is very important. The water pipe laid should be protected from heavy loads on the water pipe.

ppr管热熔操作

热熔器接通电源，到达温度指示灯亮后方能开始操作。

切割管材必须使端面垂直于管轴线，管材切割一般使用管子剪，如为大管径，则用锯条切割，切割后断面去毛刺和毛边。

Hot melt operation of PPR pipe

The heat melt can be operated after the power is turned on and the temperature indicator light is on.

The end face of the pipe must be perpendicular to the pipe axis. Pipe cutting is generally used. If the pipe diameter is large， it is cut with a saw blade. After cutting， the sected shall be deburring and burr free.

水电不同槽

水路和电路不要同槽，如果发生漏水，或者产生冷凝水时，容易浸泡到电线，这是非常危险的，好相距10cm以上。如果有水电交叉的时候，水下电上。

Different hydropower tanks

Water circuit and circuit should not be the same as the groove. If water leakage or condensate water is produced，PVC排水管加工， it is easy to soak into the wire. This's very dangerous， and it is better to be more than 10cm apart. If there is a water and electricity crossing， the underwater power is on.