ppr水管规格-卡弗龙(在线咨询)-徐汇区ppr水管

• 供货总量 : 不限
• 价格说明 : 议定
• 包装说明 : 不限
• 物流说明 : 货运及物流
• 交货说明 : 按订单

铝塑管的连接，需要使用卡套式管件，时间久了，卡套管件，受其本身材质与工作方式的影响，连接不够紧密，容易出现漏水的情况。PPR管材之间一般采用热熔焊接，当需要与其它材质的管道连接时（如钢制水管、铜制水管、热水器等），家装ppr水管，采用具有内、外丝口的铜制PPR管件连接。PPR管材与管材、管材与管件之间均采用热熔焊接，徐汇区ppr水管，焊接接口位置强度与管材一致，密封性优良。

ppr管若装在地下车库

地下车库的电气预埋前结合风管、管道图纸，避免灯具与风管和管道重叠，造成后期灯具安装时敷设明线，增加造价及影响美观。

车库车库内有桥架，但过梁较大。局部桥架过梁时可采取梁中预埋钢制套管（套管的直径不宜过大），这样避免桥架从梁下上翻，影响车库的净高。

If PPR pipe is installed in underground garage

Before the electrical pre burying of underground garage， the air duct and pipeline drawings shall be combined to avoid the overlapping of lamps with air duct and pipeline， resulting in the laying of open lines during the later installation of lamps， increasing the cost and affecting the appearance.

There is a bridge in the garage，ppr水管规格， but the lintel is large. The steel casing (the diameter of the casing should not be too large) can be embedded in the beam when the local bridge is over the beam， so as to prevent the bridge from turning up from under the beam and affecting the net height of the garage.

水电不同槽

水路和电路不要同槽，热水管ppr，如果发生漏水，或者产生冷凝水时，容易浸泡到电线，这是非常危险的，好相距10cm以上。如果有水电交叉的时候，水下电上。

Different hydropower tanks

Water circuit and circuit should not be the same as the groove. If water leakage or condensate water is produced， it is easy to soak into the wire. This's very dangerous， and it is better to be more than 10cm apart. If there is a water and electricity crossing， the underwater power is on.